Pink Bubble Bobble Vinyls for Bartop Light with curved pedestal – Outlet
This vinyl set is surplus from a print run: it is brand new and unused, and identical to the one we ship with every regular order. We have it in our workshop and are selling it at 30% off. There is only one unit.
The design is Pink Bubble Bobble, and the dimensions are those of the OmniRetro Bartop Light with curved pedestal, from the marquee down to the base of the pedestal. It does not fit other models or other pedestals.
What’s included
- Pieces: the same as the regular set for the Bartop Light with curved pedestal
- Finish: scratch-resistant matte laminate, no glare
- Print: high-definition digital print
How to apply the vinyls
They are applied with soapy water, which lets you reposition them before the adhesive fully grips.
- Surface: on raw MDF, sand with fine-grit paper and remove all the dust; on laminated board, a thorough clean is enough
- Mix: a spray bottle with water and a few drops of washing-up liquid
- Placement: wet the surface well, lay the piece on top and slide it into position
- Drying: push the water from the centre to the edges with a squeegee or a card wrapped in a soft cloth, and repeat a few hours later
- Finishing: once dry, trim the excess with a sharp craft knife
Looking for another model or finish?
If you need these vinyls for another bartop with pedestal or in gloss finish, you will find them on the Bubble Bobble Vinyls for Bartop with Pedestal page.







Reviews
There are no reviews yet.