Customise your Big Wallcade with Midnight Wanderers vinyls
Turn your Big Wallcade into a one-of-a-kind piece with this vinyl set inspired by Midnight Wanderers.
What’s in the set?
- Vinyls for the marquee and screen acrylics
- Control panel
- Middle front
- Lower front
- Vinyls for both side panels
Specifications
- Material: high-quality, hard-wearing vinyl.
- Finish: gloss or matte laminate (choose the one you prefer).
- Compatibility: made only for the OmniRetro Big Wallcade.
- Installation: on a clean surface, with a high-tack adhesive.
How to apply the vinyls
The vinyls go on with soapy water, so you can reposition them before the adhesive sets for good. Follow these steps:
- Prepare the surface. On raw MDF, sand with fine-grit sandpaper and remove all the dust thoroughly. On a laminated board, a thorough clean is enough. Dust is vinyl’s worst enemy.
- Make the mix. Fill a spray bottle with water and a few drops of washing-up liquid.
- Apply the vinyl. Spray the surface generously and lay the vinyl piece on top. The film of water lets you slide it into exactly the right position.
- Squeeze out the water. With a vinyl squeegee or a credit card wrapped in a soft cloth, push the water from the centre out to the edges with firm, even strokes.
- Let it dry. Repeat the squeegee step every few hours so no moisture stays trapped. Let it dry completely before the next step.
- Trim the excess. Once the vinyl is completely dry and stuck down, trim the excess edges with a sharp cutter.
Why choose our vinyls?
High-quality vinyls, 100% compatible with OmniRetro arcade cabinets and designed to fit each model perfectly.
Note: the vinyls are a custom product for each design. Make sure you choose the finish you want (gloss or matte) before completing your order.








Reviews
There are no reviews yet.