Regreso al Futuro Vinyls for Bartop Arcade

Regreso al Futuro Adhesive Vinyls for Bartop Arcade

Bring your bartop arcade to life with this set of Regreso al Futuro design adhesive vinyls. High-definition printing with scratch-resistant lamination to withstand daily use without losing color or sharpness.

What machines are they for?

These vinyls are designed for compact bartop arcades, without a pedestal structure. You can choose between OmniRetro models (exact measurements for each model) or the Universal Bartop format, designed for bartops of any other brand or DIY build.

Universal Bartop Format Measurements

The universal format includes the following pieces printed on a continuous sheet that you will need to cut following the marked shapes:

• Sides (×2): 56 × 71 cm
• Marquee: 60 × 13 cm
• Screen: 60 × 40 cm
• Control panel: 60 × 40 cm

OmniRetro models are shipped with measurements adjusted to each machine. The number of pieces may vary depending on the selected model.

Available Finishes

• Gloss: More saturated and vibrant colors, eye-catching effect.
• Matt: Elegant finish without reflections, ideal for environments with a lot of light.

How to Apply the Vinyls

The vinyls are applied using the water and soap technique, which allows repositioning them before the adhesive cures permanently. Follow these steps:

1. Prepare the surface. If you are applying on raw MDF, sand with fine-grit sandpaper and thoroughly clean the resulting dust. If the surface is a laminated board, thorough cleaning is sufficient. Dust is the main enemy of vinyl.
2. Prepare the mixture. Fill a spray bottle with water and a few drops of dish soap.
3. Apply the vinyl. Spray water generously over the surface and place the vinyl piece on top. The water film will allow you to slide it and adjust it to the exact position.
4. Remove the water. With a vinyl squeegee or a credit card wrapped in a soft cloth, push the water from the center towards the edges with firm, even movements.
5. Let dry. Repeat the water removal operation at intervals of several hours to ensure no trapped moisture remains. Let dry completely before the next step.
6. Trim the excess. With a sharp cutter, trim the excess edges once the vinyl is completely dry and adhered.

Technical Features

• Digital HD printing on high-quality vinyl
• Scratch-resistant lamination included
• Repositionable adhesive with water and soap technique
• Manual cutting of pieces following the printed shapes